Program renesas mcu on board with dataman

[fufufufu]

We want to buy a dataman programmer to program MCU uPD78F0485 on board.
As we know, there are two ways to program uPD78F0485, one is using 3 Wire serial I/O,
another is using UART6.
So, we want to know which mode dataman programmer is using. And we need to change
our hardware accordingly.

Which way dataman is using to program uPD78F0485 ? Please advice.
Or, please let me know which MCU (uPD78F0485) pins should be connected to dataman
programmer during programming.

[Dataman (Neil Parker)]

Dear fufufufu,

We are able to add the ISP support for this device. Please note that we are only able to add the support to the Dataman-48Pro+ and above models. The Dataman-40Pro is not able to support this device.

We have scheduled the work in and it can be done within 3-4 weeks. I will inform you when the updated software is available.

If you have any questions, please contact me.

Best regards,

Neil Parker
Dataman Programmers

[Dataman (Neil Parker)]

Dear fufufufu,

Apologies for the lengthy delay with this device support.

The ISP support for this device has now been implemented.

Please download, install and use latest OnDemand software:
URL: http://www.dataman.com/downloads/dl/fil ... ftware.zip
Version: 2.97p/05.2013

If you have any questions, please contact me.

Best regards,

Neil Parker
Dataman Programmers